English

Container Smart Planting System

From one container to a small plant factory

iHavos modular growing unit

Modular growing systems

From one container to a small plant factory.

iHavos builds controlled-environment growing capacity as prefabricated modules: a standard container, an insulated panel cabin, or a multi-layer plant factory. The same growing, fertigation and climate logic scales across all three, so a project can start small and add capacity without changing the operating model.

Each unit leaves the factory pre-assembled and tested. On site, the work is mainly to connect power and water, position the unit and start the crop.

90%water savings with closed-loop circulation
0pesticides; physical pest exclusion
3,000planting sites per 40-ft unit
60 daysaverage leafy-green cycle

Three facility forms

Same system, three ways to deploy it.

The choice is driven by site, output and how often the unit will move. All three use the same growing modules and control layer, so a project can mix them.

01

Container unit

A standard 20- or 40-ft container, factory-fitted with multi-layer racks, LED lighting, NFT channels, fertigation and climate control. It can be shipped, lifted and relocated as one unit; best for remote sites, camps and pilot production.

02

Panel cabin

Insulated panels assembled on site into a larger growing room. Width, length and layout are freer than a container, and the cabin can be extended or combined with a working area; best for a permanent site with a defined output.

03

Small plant factory

A multi-layer, fully controlled building with separated nursery, growing, harvest and utility zones. Higher output per square metre and a repeatable process; best for urban supply, fresh-cut and year-round contracts.

Multi-layer growing room inside a container
Multi-layer NFT racks use the height of the unit; one aisle serves several growing levels.

Modular architecture

Four levels, from a channel to a complete site.

The system is built from four levels. Each has a clear interface, so a container can be delivered as a complete unit or assembled from smaller modules on site.

L0 · Growing unit

Channel, growing cup and drive position; the smallest runnable unit.

L1 · Growing module

A rack with transmission, sensors and stop/lift mechanisms, plus inlet and outlet interfaces.

L2 · Function cabin

Nursery, transplanting, growing, harvest, cleaning or utility cabin; each completes one process step.

L3 · Whole site

Several cabins and modules integrated with layout, logistics and central scheduling.

Inside the unit

Three core systems, fully integrated.

01

NFT multi-layer growing

Shallow nutrient film in horizontal channels, stacked in layers. Small water volume, fast EC/pH response and uniform root-zone conditions.

02

Smart fertigation

Dosing pumps, EC/pH monitoring, filtration and a closed loop. The recipe is prepared automatically and corrected at the outlet.

03

Climate & IoT control

Cooling, dehumidification, air circulation, CO₂ and lighting are controlled by crop stage. The cloud platform reports status and supports remote diagnosis.

Fertigation dosing inside a container growing unit
Fertigation, filtration and dosing are integrated inside the unit; the operator sets a recipe, not a set of valves.

Deployment

Built for sites where conventional agriculture cannot go.

The units are designed for long supply lines, extreme climates, limited power and water, and frequent relocation. Five typical settings shape the configuration.

Remote camps & bases

Fresh vegetables close to the point of use; reduced transport loss and supply risk.

High plateau, cold or hot

Insulation, heating, cooling and dehumidification selected for the local climate.

Water-scarce sites

Closed-loop irrigation, condensate recovery and RO treatment for poor-quality sources.

Oil, mining & construction

Relocatable units that follow the project; quick connection to power and water.

Urban supply

Panel cabins and small plant factories close to the market, sized to a daily output.

Pilot & research

One container or a small cabin for variety trials, training and process validation.

Need growing capacity where there is no farm?

Tell us the site, climate, power and water conditions and target output. We will select the container, cabin or plant-factory configuration.